Landscape Lighting Wiring Methods
Assemble and place the lights low voltage landscape lights. Light fixtures usually require assembly.
Some are efficient while others are touted as easy to install but significantly decrease the energy efficiency of your system.
Landscape lighting wiring methods. Set the pathway light fixtures on the ground where theyll be installed usually about 8 to 10 feet apart. Low voltage landscape lighting connections using kichler quick discs and waterproof wire connectors are the subject of episode 38 of httprustyshoveltv. Follow the manufacturers directions.
When it comes to wiring your lighting system there are several methods commonly used. This method does a much better job of providing voltage to all the fixtures. Lay the low voltage cable along the concrete walkway following the line of light fixtures.
You run a home run wire from the transformer to a hub and then connect all your fixtures to the hub thats it. Lay the light fixtures in the approximate spots where. The hub method is simple.
Use 14 gauge cable for lighting systems that total 200 watts or less and 12 gauge cable for systems that are more than 200 watts. Youll need to snap the sockets in place at the very least and you may need to do some simple wiring. Wiring a lighting job and achieving no connections in the ground can only be done using the hub method.
Probably the most used landscape lighting wiring method is the center fed commomly known as the t method. The illustration below shows a the t method.